i talked to some of you in the chat the other night, but yeah heres my intro thread lol
my quads:
1987 Suzuki Quadracer LT500R
mods:
-AAEN Performance Mid-Range Pipe
-Keihin PWK38 Air Striker Carb
-182 Main
-62 Pilot
-5th Clip DDJ Needle(need to change)
-Boyesen Dual-Stage Reeds
-Billet Piston Thrust Washers
-Nikasiled to STD Bore Cylinder
-new OEM STD Bore Piston
-DID 520 X-Ring 98 Link Chain
-Primary Drive 14 Tooth Front/40 Tooth Rear Sprockets
-SB Designs Case Saver with Sprocket Cover
soon to come:
-White Maier Front and Rear Fenders
-New OEM Suzuki Blue Center Fender
-DDRSLAPP 1987 Reproduction Decals made for the White Maier Fenders
-100% New Bearings all around the bike(no eBay junk)
and heres how it sounds idling with the new parts
https://www.youtube.com/watch?v=pOoRHYSSLsA========
2000 Yamaha Blaster
-In The Process of a IT/YZ490 Engine Swap
Engine Work
-Dynamic Balanced Crank Assembly by Falicon Crankshafts
-Extensive Port Work and Head Remachining by Ken O'Connor Racing
-Custom Hybrid Trans from 1980 YZ465 to 1993 WR500
-100% New OEM Bearings Throughout Trans
-100% New OEM Oil Seals
-SKF Explorer Crankshaft Roller Bearings ($$$$)
Other Work
-EBC DRC Clutch Kit
-Yamaha OEM 15-Tooth Front Sprocket/Primary Drive 44-Tooth Rear Sprocket
-100% OEM New Plastics From Yamaha
-New OEM Seat Cover
-Tater Extended Swingarm and Front A-Arms
-Tusk Honda-Style Tie Rods and Ends
-Burgard Cycle Anti-Vibe Steering Stem
-TEAM Industries +3 Rear Axle
-2006 Blaster Rear Axle Carrier
-Custom Design Rear Hydraulic Brake Conversion
-Norman420 Front Hydraulic Brake Conversion Spindles
-Using 1987 Warrior Hubs and Rotors
-using 2004 YFZ450 Dual-Piston Front Calipers
-Using EBC Severe Duty Brake Pads
-Every Bolt, Bushing, Bearing, and Seal on the Quad Is Being Replaced
-Complete Frame-Up Rebuild
pics to come eventually....
man that was a lot to type lol
-Mike
Subject: yoooooooooo 
Thu Mar 10, 2011 11:25 am
